A bath liner is a new 1/4 inch thick bathtub that is custom-molded to fit right over your old bath. We come to your house and take a few measurements along with photos of your existing fiberglass, cast iron or steel bathtub. We enter these measurements into a tub identification program to determine which mold is the exact fit. Then, a sheet of acrylic is thermal-formed to your exact dimensions.

Yes. We form an acrylic shower floor liner to your floor measurements and install it over your existing tile, concrete or terrazzo base.

We install an acrylic wall system right over existing ceramic tile walls that goes from the floor to the ceiling with a bull-nose on the front edge of the two side-walls for a finished appearance. We finish with a 100% mildew resistant, silicone sealant forced into the seams that is color-matched to the walls.

YES! No need for harsh smelling, abrasive cleaners again!
DO USE Products such as: Bathroom Duck, Scrub Free, Fantastic Oxy Multi Purpose Cleaner, 50%vinegar & 50% water, 10% Bleach/90% Water, or dish detergent with degreaser, such as Dawn and Joy.
**We recommend using a sponge or soft cloth for walls & a soft brush on the slip resistant bottom.

Bath liners and shower base liners come in six solid colors: white, almond, biscuit, gray, pearl and pewter. Wall surrounds come in all four solid colors; two marble colors: almond/white and silver/white marble. A simulated or subway tile pattern wall system is also available in all four solid colors.

Yes. We custom-cut our walls to fit around the window and use color matched molding to frame your window.

Yes. We off the following matching accessories: safety grab bars, shampoo caddies, soap dishes, ceiling panels, wainscot, curved curtain rods, and more.

The actual installation takes one day and you can use the bathtub the next day.

Yes. If your bathtub or shower is in good condition, we will install the wall surround only. We can also install a bath liner by itself if your walls are solid with no leaks.

No. We fur-out the top area so the walls are installed level and go to the ceiling. This eliminates the need to paint or wallpaper, which attracts mold.

We do not recommend ‘do-it-yourself installation’ due to the skill needed to cut the acrylic.
The installation is completed by a factory-trained technician, using factory specific tools that are not sold to the general public.